Search Inventory

WC12 Series
Wood Chippers


  • Pull-type unit with drawbar
  • Adjustable discharge chute
  • Reversible, hydraulic feed roll
  • Pull-type unit with drawbar
  • Adjustable discharge chute
  • Reversible, hydraulic feed roll
  • Pull-type unit with drawbar
  • Adjustable discharge chute
  • Reversible, hydraulic feed roll

  • Pull-type unit with drawbar
  • Adjustable discharge chute
  • Reversible, hydraulic feed roll


Features

Adjustable discharge chute accurately discharges to desired location
Adjustable discharge chute with handle Adjustable discharge chute with handle
Rotates 360 degrees Rotates 360 degrees

The discharge chute rotates 360 degrees for fast and easy positioning.

 

The chute also features an adjustable deflector to accurately direct the wood chips to the desired location.

Hydraulic feedroll mounted on spring-loaded frame
WC12 Series hydraulic feedroll frame WC12 Series hydraulic feedroll frame
#

The hydraulic feedroll is mounted on a spring-loaded frame on the WC12 Series Wood Chippers, allowing it to raise up and down depending on the size of the timber going through. 

 

The speed of the feedroll can be adjusted on the side of the wood chipper with the hydraulic flow valve.

Reversible feedroll has three positions that are easy to adjust on the feed box
Feed box with handle Feed box with handle
Reversible feedroll Reversible feedroll

Engagement of the feedroll is done by pushing or pulling the handle that wraps around the outside of the feed box. The feedroll has three positions: neutral, reverse, feed (forward).

 

The feedroll grabs the material as it is fed into the chipper and allows the operator to step away while it automatically pulls material into the knives.

Self-contained hydraulic kit for WC12 Series Wood Chippers

This factory-installed, self-contained hydraulic kit is for tractors with less than 22.7 L/min (6 gpm) of hydraulic capacity or with no available rear selective control valves (SCVs). The kit contains a hydraulic reservoir and power take-off (PTO) driven hydraulic pump.

Specs & Compare

ADD MODEL

Dimensions

WC12 Series
Current Model
Chip opening229x406 mm
9x16 in.
Hopper opening711x1067 mm
28x42 in.

Feed options

SystemHydraulic
Feed_x001A_roller diameter393.7 mm
15.5 in.
Hopper height68.6 cm
27.5 in.

Chip chute

Fixed
AdjustableRotation: 360 degree (angle)

Weights

Unit1161.2 kg
2560 lb
Rotor styleDrum
Rotor222.3 kg
490 lb

Tractor compatibility

PTO rpm540 rpm
HP range (Tractor PTO hp)56-86 kW
75-115 hp

3-Point hitch

CategoryPull-type
iMatch™ or Quik-Coupler

Hydraulics

Requirements30.3 L/min
8 gpm
Self-contained systemOptional

Chipping

Knife quantityTwo
Knife size1.59x11.43x22.86 mm
0.625x4.5x9 in.
Knife boltGr 8 hex head bolts: 15.9 mm
0.625 in.
Shear barA8 Hardened Anvil
Rotor rpm2050 rpm

Belt drive system

NumberFive
TypeB-7 banded belt

Set-up time

Warranty

Additional information

Offers & Discounts

No current offers.

Videos